How To Cut Crown Molding For Angled Ceiling Planks

Crown molding is a type of decorative trim that is used to finish the joint where a wall and ceiling meet. It can be a beautiful addition to any room, but it can be tricky to cut and install, especially on an angled ceiling.

If you're not sure how to cut crown molding for an angled ceiling, don't worry. This guide will walk you through the steps step-by-step.

Materials You'll Need

Crown molding
Miter saw
Measuring tape
Pencil
Safety glasses

Step-by-Step Instructions

1. Measure the Length of the Crown Molding

The first step is to measure the length of the crown molding you need. To do this, use a measuring tape to measure the distance from the inside corner of the wall to the outside corner of the wall. Add 1 inch to this measurement to allow for overlap.

2. Mark the Crown Molding

Once you have the length of the crown molding, mark it on the molding using a pencil. Use a square to draw a line perpendicular to the edge of the molding at the mark you made.

3. Cut the Crown Molding

Place the crown molding on the miter saw so that the mark you made is aligned with the saw blade. Holding the molding firmly in place, slowly lower the saw blade down through the molding.

4. Repeat Steps 1-3 for the Other Side of the Crown Molding

Once you have cut the first piece of crown molding, you need to repeat steps 1-3 for the other side of the molding. This will give you two pieces of crown molding that are cut at a 45-degree angle.

5. Dry Fit the Crown Molding

Before you install the crown molding, it's a good idea to dry fit it to make sure that it fits properly. To do this, place the two pieces of crown molding together at the corner of the wall. If the pieces fit together snugly, you're ready to install them.

6. Install the Crown Molding

To install the crown molding, apply a bead of caulk to the back of the molding. Then, place the molding in place and press it firmly into the corner of the wall. Use a nail gun to secure the molding in place.

7. Caulk and Paint

Once the crown molding is installed, you can caulk any gaps between the molding and the wall. Then, you can paint the molding to match the rest of the trim in your room.

Tips for Cutting Crown Molding for Angled Ceilings

Use a sharp saw blade. A dull saw blade will make it difficult to cut through the crown molding cleanly.
Hold the molding firmly in place while you're cutting it. This will help to prevent the molding from moving and causing the cut to be uneven.
Dry fit the molding before you install it. This will help you to make sure that the molding fits properly and that there are no gaps between the molding and the wall.
Caulk any gaps between the molding and the wall. This will help to keep the molding in place and prevent drafts.

Conclusion

Cutting crown molding for angled ceilings can be a tricky task, but it's not impossible. By following the steps outlined in this guide, you can achieve professional-looking results.